I am having a hard time finding any options other than the couple that kimber offers A forum community dedicated to kimber firearm owners and enthusiasts Would a standard 1911 rail holster probably work
Kimber West's Birthday Celebration | HappyBday.to
Maybe a edc x9 rail holster
I am looking for an iwb.
My third kimber revolver, purchased and registered in late july '24, is at a local gunsmith shop after the diagnosis Broken firing pin and spring The 2 da snubbie quickly became my favorite for cc My range log shows over 50 cylinders (about 300 rounds) fired as i tried as many kinds of.
Personally i’m not concerned about kimber’s mim parts or even the polymer msh I don’t have plastic msh because i opted to install units with the magazine well on my custom and ultra The previous owner had installed a matching pattern msh on the raptor but also provided the oem plastic one The unit on my custom was quite expensive at the time from ed brown because this was in the early.
Kimber would be far better advised to delete barrel fluting, and focus on accuracy areas
Barrel hood length and width fit to slide, bottom lug fit to slide stop, and muzzle area fit of barrel to slide Slide to frame fit is okay, but not great Chamber throat areas should be considered as well Most 9mm's benefit from a throating reamer.
Kimber cs is correct, the number of problems is exceptionally low It’s just that visibility is very high due to ease of access Regardless of the product, there’s an overwhelming high number of people whose first post is to complain Hey all, new to kimber, always been a fan
I recently purchased two kds 9mm's, and a cds 9mm
For the range i typically use winchester nato 124 gr ammo All three guns are constantly jamming
