Equipment bollard in a residential garage we have a minimum 36 inch high 2 schedule 40 iron pipe embedded in the garage slab Here is the citation from the international residential code (irc) We also have two alternates that are wheel stops and pipes bolted to the floor for retrofits
Best 11 Jennette McCurdy Leaked Nudes – Bing – Artofit
99% of the time we see the schedule 40 pipe embedded in the concrete.
Codes do not permit duct openings in a residential attached garage, for obvious reasons
I ran across one yesterday where it appears that the contractor is placing an air handler in a garage under living space In the picture provided, i would say that is still a single portal frame opening I think the intent was to prevent two portal frames immediately adjacent to each other using a common header 16' garage door headers conarb said
It's not that simple, almost all garage door headers require portal design, and usually narrow portals integrated with the header, this always requires engineering, listen to your uncle In areas with significant lateral loads from sesmic or wind, yes In areas without such loads, it's not such an issue. I would not interpret measuring from overhang
Any other comments on that
I'll probably stay 5' back The area where the two structure meet is only about 30 of wall length, but there is a window in the garage in that 30. The diagram shows a section view of a draft of my new home Cars will enter the two car garage towards you, over a 4' frost wall
There are two sections of 4' frost wall that extend on each end of the full height foundation wall on the left, and there are 4' frost walls at the rear of the. I do not see anywhere in the irc 2015 that requires a step from the garage into the house I saw the opening penetrations r302.5 & garage section r309 Is the step still a requirement and if so is there a minimum dimension?
This was an existing empty space above the garage
They don't want a landing on top of the stairway that goes to this space. The stairway is being built in the garage but will have a wall built. Irc the building code requires that a garage floor be sloped towards the door, but does not specify a minimum slope It is usually 1/8” to 1/4” per foot
